How do you change a Delta shower diverter valve?

Can you change a shower diverter without turning off the water?

If you’re only working on the diverter, you don’t need to turn off the water supply to the faucet. While working, place a cloth over the tub drain to prevent any dropped screws from going down the drain. Some showers use a diverter built into the tub spout activated by lifting a button on the spout.

How do you install a Delta shower diverter?

Quote from the video:
You want to make sure when you install your tef tape to go in the same. Direction at which the fitting turns to tighten. So we'll go ahead and wrap this about about six times or. So.

How do you change the diverter?

Quote from the video:
So it just slides up bit of copper pipe that is on there and there's an o-ring inside of this fitting that keeps it nice and snug keeps it from leaking. So on the pipe.

How do you remove a shower diverter cover?

Quote from the video:
And pull it off as you wiggle it and pull it off just be careful you don't want to harm the inner portion of the plumbing you do not want to cause them internal leak. Set that in a safe location.

How do you install a Delta diverter valve?

Quote from the video:
Be set at the right depth. So i just used some wood blocking to accomplish that i screwed it in place made sure my horizontal pipe was nice and level and then i prepped.

How do you install a shower diverter valve?

Quote from the video:
Out where i'm going to place my valve. How i'm going to run my hot and cold water and how i'm going to route my rain. And my shower spout it also gives me a great opportunity to count all the elbows.

See also  What is the size of a bathroom stall?

How do you remove a Delta single handle shower faucet?

Quote from the video:
Take off the knob cover and remove the screw holding on the temperature. Knob. Use an allen wrench to loosen the set screw and remove the handle assembly. Take off the trim sleeve.