What is eo2 on lazy spa?

Is there an E02 error code displaying on your Lay-Z-Spa pump? This means your Lay-Z-Spa pump is experiencing a water flow issue.

What does E02 on hot tub mean?

The E02 error code can occur when the filters are dirty or blocked. SOLUTIONS WASH OR CHANGE THE FILTERS. Remove the filter cartridge from the filter housing. Using luke warm water, run the filter cartridge under the water until it runs clear.

How do you fix the error code on a hot tub?

How to Troubleshoot a Hot Tub FLO Error Code

  1. Shut down the spa at the breaker.
  2. Make sure there is no debris in the water that can get sucked into the pump.
  3. Take out all of the filter(s) and set them aside.
  4. Turn spa back on at the breaker with the filters out.


How do I fix E02 error on my Coleman hot tub?

Quote from the video:
It on its side fill the ports with vinegar. Let it set overnight pour the vinegar out. And then you take garden hose attach. It to the bottom and put that sucker on full-blast. You will be amazed.

What does E02 mean on a Bosch dishwasher?

The E02 error code on the Bosch dishwasher display means there is a problem of heating water because of electronics. In fact, the explanation is not sufficient. The electronics include not only the control module but also the wiring of the entire circuit containing the heating element and the board.

How long does a filter last in a lazy spa?

Between each use or at least every other day you should remove the filter cartridge from its filter housing and clean them. Every few weeks depending on the intensity of your hot tub use, old filters should be replaced with new ones (especially when they become harder and discoloured).

See also  Can I bleach satin?

What does F8 mean on a hot tub?

Filtration Cycles run from F1 to F8 (F1 = 1 hour every 12 hours / F8 = 8 hours every 12 hours). Preset cycle set from factory is F1, so if in ec or sl mode your water will not reach desired temperature.

What does F2 mean on a hot tub?

The Big List of Spa and Hot Tub Error Codes

CODE ERROR CODE DESCRIPTION
F1, F2 (Vita Spa) Blown fuse; replace fuse 1 or fuse 2
F2 4 hours daily filtration; system message, not an error
F4 8 hours daily filtration; system message, not an error
F6 12 hours daily filtration; system message, not an error

What does P mean on hot tub?

A “P” will be displayed when the pump is not on, to indicate that the water near the temperature sensors must be purged to get an accurate reading of the water temperature. To display the water temperature when “P” is showing on the display, press the “JETS” button. After 2 minutes, the water temp will be displayed.

What is E02 washing machine?

E02 – the machine has failed to fill with water during its allocated time. Check the mains water pressure, by turning on the sink taps and checking for the usual pressure, if this is ok check the inlet hose for kinks, the pressure switch and inlet valve.

What does E02 mean on a lamona dishwasher?

Error Code E02 – no water – indicating the float has stuck in the raised position, or there’s an issue with the inlet screen or inlet valve. The water inlet valve controls the flow of both hot and cold water and must be replaced with components that are specific to your model.

See also  What is a pareo skirt?